Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT AIRBAG SENSOR

FRONT AIRBAG SENSOR > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL FRONT AIRBAG SENSOR LH
  1. Install the front airbag sensor LH with the 2 bolts.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

    NOTICE:
    1. If the front airbag sensor LH has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
    2. When installing the front airbag sensor LH, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

  1. Connect the connector.

  1. Check that there is no looseness in the installation parts of the front airbag sensor LH.



2. INSTALL FRONT BUMPER COVER (w/o Intuitive Parking Assist System)
(Click here)


3. INSTALL FRONT BUMPER COVER (w/ Intuitive Parking Assist System)
(Click here)


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



5. CHECK SRS WARNING LIGHT
(Click here)