Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT AIRBAG SENSOR

FRONT AIRBAG SENSOR > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE FRONT BUMPER COVER (w/o Intuitive Parking Assist System)
(Click here)


3. REMOVE FRONT BUMPER COVER (w/ Intuitive Parking Assist System)
(Click here)


4. REMOVE FRONT AIRBAG SENSOR LH


    B240197
  1. Disconnect the connector.

  1. Remove the 2 bolts and front airbag sensor LH.