Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > Cruise Main Indicator Light Circuit

for Preparation Click here


DESCRIPTION

  1. When the ECM detects a cruise control switch on signal from the cruise control switch, it sends it to the combination meter through CAN communication. Then the cruise main indicator light turns on.
  2. The cruise main indicator light circuit uses CAN communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.

INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING TECHSTREAM (CRUISE MAIN INDICATOR LIGHT)
  1. Select the item below in the Active Test, and then check that the cruise main indicator light illuminates (Click here).

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Indicat. Lamp Cruise
    Cruise main indicator light
    ON/OFF
    -

    OK:
    Indicator light turns on/off.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK


2.READ VALUE USING TECHSTREAM (CRUISE CONTROL SWITCH)
  1. Use the Data List to check if the cruise main indicator light is functioning properly (Click here).

    Cruise Control 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    CCS Indicator M-CPU
    Cruise main indicator (Main CPU) / ON or OFF
    ON: Cruise main indicator light on
    OFF: Cruise main indicator light off
    -

    OK:
    On screen, item changes between ON and OFF according to above chart.

    Result 
    Result
    Proceed to
    OK
    A
    NG
    B



B
REPLACE ECM (Click here)
A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)