Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
  1. Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to this system before inspecting the suspected areas below.


Cruise Control System 
Symptom
Suspected Area
See page
Cruise control switch cannot be turned on (Cruise main indicator in combination meter does not illuminate)
Cruise control switch circuit
Click here
Cruise main indicator light circuit
Click here
ECM
Click here
SET not occurring or CANCEL occurring (DTC is not output)
Cruise control switch circuit
Click here
Combination meter assembly
Click here
ECM
Click here
Actual vehicle speed deviates above or below set speed
Master cylinder solenoid (Skid control ECU)
Click here
ECM
Click here
Cruise control not canceled when brake pedal is depressed
Stop light switch circuit
Click here
ECM
Click here
Cruise control not canceled when shift lever is moved to N
Park/neutral position switch assembly
Click here
ECM
Click here
Control switch does not operate (-SET, +RES, CANCEL not possible)
Cruise control switch circuit
Click here
ECM
Click here
SET possible at 40 km/h (25 mph) or less, or CANCEL does not operate
Master cylinder solenoid (Skid control ECU)
Click here
ECM
Click here
Poor response in ACCEL and RESUME modes
Cruise control switch circuit
Click here
ECM
Click here
DTC memory is cleared
ECM
Click here
DTC is not output or is output when it should not be
TC and CG terminal circuit
Click here
ECM
Click here
Cruise main indicator light does not illuminate
Cruise control switch circuit
Click here
Cruise main indicator circuit
Click here
Combination meter assembly
Click here
ECM
Click here
SET indicator does not come on (SET function operates normally)
Cruise SET indicator light circuit
Click here
ECM
Click here