CRUISE CONTROL SYSTEM > Cruise SET Indicator Light Circuit |
| 1.PERFORM ACTIVE TEST USING TECHSTREAM (SET INDICATOR LIGHT) |
Select the item below in the Active Test, and then check that the SET indicator light illuminates (Click here).
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Indicat. SET | SET indicator light | ON/OFF | - |
|
| ||||
| OK | |
| 2.READ VALUE USING TECHSTREAM (CRUISE CONTROL SWITCH) |
Use the Data List to check if the cruise control switch is functioning properly (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| SET/COAST Switch | -SET switch signal / ON or OFF | ON: -SET switch on OFF: -SET switch off | - |
| Result | Proceed to |
| OK | A |
| NG | B |
|
| ||||
| A | ||
| ||