DTC P0196 Engine Oil Temperature Sensor (Range/Performance) |
DTC P0197 Engine Oil Temperature Sensor Low |
DTC P0198 Engine Oil Temperature Sensor High |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0196 | Despite estimated engine oil temperature is higher than 45°C (113°F), engine oil temperature sensor value is lower than 45°C (113°F). (2 trip detection logic) |
|
| P0197 | Engine oil temperature sensor voltage is less than 0.203 V for 0.5 seconds or more. (1 trip detection logic) | |
| P0198 | Engine oil temperature sensor voltage is more than 4.698 V for 0.5 seconds or more. (1 trip detection logic) |

| GTS Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| 1.READ VALUE USING GTS (ENGINE OIL TEMPERATURE) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Data List / Engine Oil Temperature.
Read the value displayed on the GTS.
| Result | Proceed to |
| -40°C (-40°F) | A |
| 215°C (419°F) | B |
| Between 75 and 100°C (167 and 212°F) | C |
|
| ||||
|
| ||||
| A | |
| 2.READ VALUE USING GTS (ENGINE OIL TEMPERATURE) |
![]() |
Disconnect the Engine oil temperature sensor connector.
Connect terminals 1 and 2 of the Engine oil temperature sensor connector on the wire harness side.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Data List / Engine Oil Temperature.
Read the value displayed on the GTS.
| *1 | Engine oil temperature sensor |
| *2 | ECM |
| *a | Front view of wire harness connector (to Engine oil temperature sensor) |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (ECM - ENGINE OIL TEMPERATURE SENSOR) |
Disconnect the engine oil temperature sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A36-20 (OT) - C21-2 (OT) | Always | Below 1 Ω |
| A36-29 (E1) - C21-1 (E2) | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||
| 4.READ VALUE USING GTS (ENGINE OIL TEMPERATURE) |
![]() |
Disconnect the Engine oil temperature sensor connector.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Data List / Engine Oil Temperature.
Read the value displayed on the GTS.
| *1 | Engine oil temperature sensor |
| *2 | ECM |
|
| ||||
| OK | ||
| ||
| 5.CHECK HARNESS AND CONNECTOR (ECM - ENGINE OIL TEMPERATURE SENSOR) |
Disconnect the engine oil temperature sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A36-20 (OT) or C21-2 (OT) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||