CRUISE CONTROL SYSTEM > Cruise Control Switch Circuit |

| 1.READ VALUE ON GTS |
![]() |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Select the following menu items: Powertrain / Cruise Control / Data List.
Check the Data List to confirm proper functioning of the cruise control main switch.
| *a | ON-OFF |
| *b | -/SET |
| *c | +/RES |
| *d | CANCEL |
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Main SW M-CPU | Cruise control main switch signal (Main CPU) / ON or OFF | ON: cruise control main switch (ON-OFF button) pushed OFF: cruise control main switch (ON-OFF button) released | - |
| Cancel Switch | CANCEL switch signal / ON or OFF | ON: CANCEL switch on OFF: CANCEL switch off | - |
| SET/COAST Switch | -/SET switch signal / ON or OFF | ON: -/SET switch on OFF: -/SET switch off | - |
| RES/ACC Switch | +/RES switch signal / ON or OFF | ON: +/RES switch on OFF: +/RES switch off | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT CRUISE CONTROL MAIN SWITCH ASSEMBLY |
Inspect the cruise control main switch assembly (Click here).
|
| ||||
| OK | |
| 3.CHECK CRUISE CONTROL MAIN SWITCH WIRE |
![]() |
Disconnect the cruise control main switch assembly connector.
Disconnect the spiral cable with sensor sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| Cruise control main switch side connector terminal 3 (R) - z5-4 | Below 1 Ω |
| Cruise control main switch side connector terminal 1 (B) - z5-3 | Below 1 Ω |
| *a | Front view of wire harness connector (to Spiral Cable with Sensor Sub-assembly) |
| *b | Front view of wire harness connector (to Cruise Control Main Switch Assembly) |
|
| ||||
| OK | |
| 4.INSPECT SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY |
Inspect the spiral cable with sensor sub-assembly (Click here).
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY - ECM AND BODY GROUND) |
Disconnect the ECM connector.
Disconnect the spiral cable with sensor sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A33-30 (CCS) - D51-11 (CCS) | Always | Below 1 Ω |
| A33-4 (EC) - D51-10 (ECC) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| A33-30 (CCS) or D51-11 (CCS) - Body ground | Always | 10 kΩ or higher |
| A33-4 (EC) or D51-10 (ECC) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||