Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



DESCRIPTION
When troubleshooting a vehicle with a diagnosis system, the only difference from the usual troubleshooting procedure is connecting the GTS to the vehicle and reading various data output from the skid control ECU.
The skid control ECU records DTCs when it detects a malfunction in itself or in its circuits.
To check for DTCs, connect the GTS to the DLC3 on the vehicle. The GTS can be used to clear the DTCs, activate various actuators, and check the Freeze Frame Data and Data List.
  1. Check the battery voltage.

    Standard Voltage:
    11 to 14 V

    If the voltage is below 11 V, recharge the battery before proceeding to the next step.

  2. Check the DLC3 (Click here).


DIAGNOSIS
  1. If the skid control ECU detects a malfunction, the ABS warning, brake warning, and/or slip indicator lights will come on in order to warn the driver.

  2. The DTCs are simultaneously stored in memory.
    The DTCs can be read by connecting the GTS (Click here).

  3. This system has a Test Mode (signal check) function.
    The DTCs can be read by connecting the GTS (Click here).


WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK
  1. Release the parking brake.

    NOTICE:
    Before releasing the parking brake, move the shift lever to P (for automatic transmission) or set chocks to prevent the vehicle from rolling.

    HINT:
    When the parking brake is applied or the brake fluid level is low, the brake warning light comes on.

  2. When the ignition switch is turned to ON, check that the ABS warning, brake warning, TRC OFF indicator, VSC OFF indicator, TRACK indicator and slip indicator lights all come on.

    HINT:
    1. If the warning light and indicator light check result is not normal, proceed to troubleshooting for the ABS warning, brake warning, TRC OFF indicator, VSC OFF indicator, TRACK indicator and slip indicator light circuits.
    2. If any of the indicators remains on or does not come on, proceed to troubleshooting for the light circuits listed below.

    Trouble Area
    See Procedure
    ABS warning light circuit (Remains on)
    Click here
    ABS warning light circuit (Does not come on)
    Click here
    Brake warning light circuit (Remains on)
    Click here
    Brake warning light circuit (Does not come on)
    Click here
    TRC OFF indicator light circuit (Remains on)
    Click here
    TRC OFF indicator light circuit (Does not come on)
    Click here
    VSC OFF indicator light circuit (Remains on)
    Click here
    VSC OFF indicator light circuit (Does not come on)
    Click here
    TRACK indicator light circuit (Remains on)
    Click here
    TRACK indicator light circuit (Does not come on)
    Click here
    Slip indicator light circuit (Remains on)
    Click here
    Slip indicator light circuit (Does not come on)
    Click here
    Hill start assist indicator circuit
    Click here

    1. When the ignition switch is turned to ON, check that the brake warning, TRC OFF indicator, VSC OFF indicator and TRACK indicator lights turn off after 3 seconds.

    2. When the engine is started, check that the ABS warning and slip indicator lights turn off after 3 seconds.