Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > TRACK Indicator Light Remains ON

for Preparation Click here


DESCRIPTION

The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication.
When the TRACK switch is operated, the system switches between normal mode and sport mode.
If the TRACK switch is pressed in normal mode, the system enters sport mode.

WIRING DIAGRAM


C264064E05


INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU (brake actuator assembly), perform VSC sensor neutral memorization (Click here).

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).

    Result:

    Result
    Proceed to
    DTC is not output.
    A
    DTC is output.
    B



B
INSPECT CAN COMMUNICATION SYSTEM (Click here)
A


2.CHECK IF BRAKE ACTUATOR ASSEMBLY CONNECTOR IS SECURELY CONNECTED
  1. Check if the skid control ECU (brake actuator assembly) connector is securely connected.

    OK:
    The connector is securely connected.



NG
CONNECT CONNECTOR TO ECU CORRECTLY
OK


3.CHECK BATTERY
  1. Check the battery voltage.

    Standard Voltage:
    11 to 14 V



NG
CHECK OR REPLACE CHARGING SYSTEM COMPONENT OR BATTERY (Click here)
OK


4.READ VALUE USING GTS (TRACK SWITCH)
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Select the Data List using the GTS (Click here).

    ABS/VSC/TRC 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    TRACK Mode
    TRACK mode / Normal or TRACK
    Normal: Normal mode
    TRACK: TRACK mode
    -

  1. Using the GTS, check that the switch condition displayed on the GTS changes according to TRACK switch operation.

    OK:
    The GTS display changes according to TRACK switch operation.



NG
Go to step 6
OK


5.INSPECT COMBINATION METER ASSEMBLY
  1. Perform an Active Test of the combination meter assembly (meter CPU) using the GTS (Click here).

  1. Check the combination meter assembly.

    OK:
    The TRACK indicator light turns on or off in accordance with the Active Test operation.

    HINT:
    If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts (Click here).



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)  

6.INSPECT TRACK SWITCH
  1. Remove the TRACK switch (Click here).

  1. Inspect the TRACK switch (Click here).



NG
REPLACE PATTERN SELECT SWITCH ASSEMBLY (Click here)
OK


7.CHECK HARNESS AND CONNECTOR (BRAKE ACTUATOR ASSEMBLY - TRACK SWITCH)
  1. Disconnect the skid control ECU (brake actuator assembly) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A5-9 (CSW2) - D35-1
    Always
    Below 1 Ω
    A5-9 (CSW2) - Body ground
    Always
    10 kΩ or higher
    D35-8 - Body ground
    Always
    Below 1 Ω

    HINT:
    If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)