ENTRY AND START SYSTEM (for Entry Function) > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
| What? | Vehicle model, system name |
| When? | Date, time, occurrence frequency. Does it occur recently or for a long time? |
| Where? | Does it occur at specified place? |
| Under what conditions? | Unlock/lock the door, engine switch on (IG), engine start. |
| How did it happen? | Problem symptoms* |
| |||||
| 3.INSPECT BATTERY VOLTAGE |
| |||||
| 4.CHECK VEHICLE STABILITY CONTROL SYSTEM* |
Use the GTS to check if the VSC system is functioning normally.
| Result | Proceed to |
| No vehicle speed signal is mistakenly received. | A |
| A vehicle speed signal is mistakenly received. | B |
|
| ||||
| |||||
| 5.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
Use the GTS to check if the CAN communication system is functioning normally (Click here).
| Result | Proceed to |
| CAN DTC is not output | A |
| CAN DTC is output | B |
|
| ||||
| |||||
| 6.CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM* |
Use the GTS to check if the LIN communication system is functioning normally (Click here).
| Result | Proceed to |
| LIN DTC is not output | A |
| LIN DTC is output | B |
|
| ||||
| |||||
| 7.CHECK FOR DTC* |
Recheck for DTCs (Click here). Based on the DTCs output, proceed each system's DTC procedure.
| Result | Proceed to |
| DTC is not output | A |
| Steering lock system DTC is output | B |
| Engine immobiliser system DTC is output | C |
| Entry and start system (for entry function) DTC is output | D |
|
| ||||
|
| ||||
|
| ||||
| |||||
| 8.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
| Result | Proceed to |
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
|
| ||||
| |||||
| 9.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Operation Check (Click here).
Check Data List / Active Test (Click here).
Check Terminals of ECU (Click here).
| |||||
| 10.REPAIR OR REPLACE |
| |||||
| 11.CHECK FOR DTC* |
Clear the DTCs (Click here).
Check for DTCs (Click here).
| Result | Proceed to |
| DTC is not output | A |
| Entry and start system (for entry function) DTC is output | B |
|
| ||||
|
| ||||
|---|---|---|---|---|---|