Home › Vehicle Interior › DOOR LOCK › KEY REMINDER WARNING SYSTEM (w/o Entry and Start System)

KEY REMINDER WARNING SYSTEM (w/o Entry and Start System) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the key reminder warning system.
  2. *: Use the GTS.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE
    1. Check the battery voltage.

    2. Standard voltage:
      11 to 14 V

      HINT:
      If the voltage is below 11 V, recharge or replace the battery before proceeding.


    NEXT


    3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Using the GTS, inspect the CAN communication function to ensure that there are no malfunctions in the communication system (Click here).
      Result 
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B



    B.
    GO TO CAN COMMUNICATION SYSTEM (Click here).
    A


    4.PROBLEM SYMPTOMS TABLE
      Result 
      Result
      Proceed to
      Fault is not listed on Problem Symptoms Table
      A
      Fault is listed on Problem Symptoms Table
      B


    B.
    Go to step 6
    A


    5.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Terminals of ECU (Click here).

    2. Data list/Active test (Click here).


    NEXT


    6.REPAIR OR REPLACE

      NEXT


      7.CONFIRMATION TEST

        NEXT

        END