Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Illumination Circuit

for Preparation Click here


DESCRIPTION

Power is supplied to the radio receiver assembly and satellite switch assembly illumination when the light control switch is in the tail or head position.
  1. *: for TFT Meter Type

WIRING DIAGRAM


E351765E03


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following procedure.

1.CHECK ILLUMINATION
  1. Check if the illumination for the radio receiver assembly, steering pad switch assembly or others (hazard switch, heater control switch, etc.) comes on when the light control switch is turned to the head or tail position.

    1. *: for TFT Meter Type

    Result:

    Result
    Proceed to
    Illumination comes on for all components except radio receiver assembly.
    A
    Illumination comes on for all components except steering pad switch assembly.
    B
    No illumination comes on (radio and display receiver assembly, hazard switch, heater control switch, etc.).
    C



B
Go to step 3

C
GO TO LIGHTING SYSTEM (Click here)
A


2.CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL)
  1. Disconnect the D14 radio and display receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Voltage:

    Tester Connection
    Condition
    Specified Condition
    D14-10 (ILL+) - Body ground
    Light control switch in tail or head position
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

3.CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL)
  1. Disconnect the D77 spiral cable with sensor sub-assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:

    Tester Connection
    Condition
    Specified Condition
    D77-3 (ILL+) - Body ground
    Light control switch in tail or head position
    11 to 14 V



NG
REPLACE STEERING PAD SWITCH ASSEMBLY (Click here)
OK


4.INSPECT SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
  1. Remove the spiral cable with sensor sub-assembly. (Click here )

  1. Inspect the spiral cable with sensor sub-assembly. (Click here)



NG
REPLACE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY (Click here)
OK


5.INSPECT STEERING PAD SWITCH ASSEMBLY
  1. Remove the steering pad switch assembly. (Click here)

  1. Inspect the steering pad switch assembly. (Click here)



NG
REPLACE STEERING PAD SWITCH ASSEMBLY (Click here)
OK


6.CHECK SPIRAL CABLE WITH SENSOR SUB ASSEMBLY - COMBINATION METER ASSEMBLY
  1. Disconnect the D78 spiral cable with sensor sub-assembly connector.

  1. Disconnect the D7 combination meter assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Resistance:

    Tester Connection
    Condition
    Specified Condition
    D77-4 (ILL-) - D7-9 (ILL-)
    Always
    Bellow 1 Ω



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR