Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM

DTC    B1247    Tire Pressure Monitor Receiver Communication Stop

for Preparation Click here


DESCRIPTION

The main body ECU (network gateway ECU) and tire pressure warning ECU and receiver are connected using 2 direct lines that they use to communicate with each other.

DTC No.
DTC Detection Condition
Trouble Area
B1247
In diagnostic mode, an applicable RDA signal cannot be received within 10 seconds with the ignition switch ON.
  1. Tire pressure warning ECU and receiver
  2. Wire harness or connector
  3. Main body ECU (network gateway ECU)

WIRING DIAGRAM


C305299E02


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU and receiver, read the IDs stored in the old ECU using the GTS and write them down before removal.
  2. It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU after the ECU has been replaced.

HINT:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU (NETWORK GATEWAY ECU) -TIRE PRESSURE WARNING ECU AND RECEIVER)
  1. Disconnect the H28 tire pressure warning ECU and receiver connector and the D6 main body ECU (network gateway ECU) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H28-4 (BRDA) - D6-7 (RDA)
    Always
    Below 1 Ω
    H28-5 (BPRG) - D6-6 (PRG)
    Always
    Below 1 Ω
    D6-7 (RDA) - Body ground
    Always
    10 kΩ or higher
    D6-6 (PRG) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (POWER SOURCE OF TIRE PRESSURE WARNING ECU AND RECEIVER)
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H28-12 (GND) - Body ground
    Always
    Below 1 Ω



    C239106E10
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    H28-1 (IG) - Body ground
    Ignition switch ON
    11 to 14 V

Text in Illustration 
*a
Front view of wire harness connector
(to Tire Pressure Warning ECU and Receiver)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER
  1. Replace the tire pressure warning ECU and receiver (Click here).


NEXT


4.CHECK DTC OUTPUT (B1247)
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch to ON.

  1. Check for DTCs (Click here).

    OK:
    DTC B1247 is not output.



NG
REPLACE MAIN BODY ECU (NETWORK GATEWAY ECU) (Click here)
OK

END