Home › Drivetrain ยท TL70 MANUAL TRANSMISSION / TRANSAXLE › SHIFT LEVER ASSEMBLY

SHIFT LEVER ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
The power window system utilizes a mechanism in which the door glass moves down slightly when the door is opened, and in which the glass moves up when the door closed in order to prevent the door molding from being damaged. When the negative (-) battery terminal needs to be disconnected for servicing, fully open the driver and passenger door glasses in advance.



2. REMOVE CONSOLE BOX ASSEMBLY
(Click here)


3. REMOVE SHIFT LEVER BOOT


    C260582
  1. Remove the 2 clips and the shift and select lever cover.



    C260583
  1. Disconnect the wire harness clamp.

  1. Remove the 4 bolts, the shift and select lever retainer and the shift lever boot.



4. REMOVE SHIFT LEVER CAP


    C260584
  1. Remove the 4 bolts and the shift lever cap.



5. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY
(Click here)


6. REMOVE FLOOR SHIFT LEVER ASSEMBLY


    C260585
  1. Turn over the shift and select lever boot.

  1. Using a screwdriver, remove the clip and the floor shift lever assembly.

  1. Remove the plate washer from the floor shift lever assembly.

  1. Remove the 2 bushings and O-ring from the floor shift lever assembly.



7. REMOVE SHIFT AND SELECT LEVER BOOT
  1. Remove the shift and select lever boot from the floor shift lever assembly.



8. REMOVE FLOOR SHIFT CONTROL SHIFT LEVER RETAINER SUB-ASSEMBLY


    C260586
  1. Remove the 2 bolts and separate the floor shift control shift lever retainer sub-assembly.



    C261652
  1. Remove the floor shift control shift lever retainer sub-assembly.



9. REMOVE MANUAL TRANSMISSION ASSEMBLY
(Click here)


10. REMOVE FLOOR SHIFT CONTROL SHIFT LEVER RETAINER


    C262640
  1. Pull up the locks of the shift lever pins, and remove the 2 shift lever pins.

  1. Remove the floor shift control shift lever retainer.



11. REMOVE SHIFT LEVER RETAINER BUSHING


    C261651
  1. Remove the 4 shift lever retainer bushings.



12. REMOVE FLOOR SHIFT CONTROL SHAFT


C262641
  1. Using a screwdriver, remove the clip, plate washer and floor shift control shaft.

  1. Remove the 2 collars from the control shaft.



13. REMOVE CONTROL SHAFT


C262642E01
  1. Using a hammer and a screwdriver, cut off the control shaft collar and remove it from the shift shaft.

  1. Using a hexagon bar wrench, push the shaft pin up from the bottom. Attach a piece of cloth to protect the shaft pin from damage, and then remove the shaft pin using a pair of pliers.

  1. Remove the shift lever damper from the control shaft.
    Text in Illustration 
    *1
    Control Shaft Collar
    *2
    Shaft Pin
    *3
    Control Shaft
    *4
    Shift Lever Damper
    *5
    Shift Shaft