AUTOMATIC TRANSMISSION SYSTEM > Shift Paddle Switch Circuit |

| 1.READ VALUE USING GTS |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Read the value displayed on the GTS.
| Tester Display | Condition | Standard |
| Sport Shift Up SW | Continuously shift to "+" (upshift): ON Release "+" (up-shift): OFF | - |
| Sport Shift Down SW | Continuously shift to "-" (down-shift): ON Release "-" (down-shift): OFF | - |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (TRANSMISSION SHIFT SWITCH - TCM) |
Disconnect the TCM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A19-1(SFTD) - Body ground | Pull continuously "+" (Up shift) | Below 1 Ω |
| Release "+" or "-" | 10 kΩ or higher | |
| A19-2(SFTU) - Body ground | Pull continuously "-" (Down shift) | Below 1 Ω |
| Release "+" or "-" | 10 kΩ or higher |
Connect the TCM connector.
|
| ||||
| OK | |
| 3.REPLACE TCM |
Replace the TCM (Click here).
| NEXT | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (SPIRAL CABLE - BODY GROUND) |
Disconnect the spiral cable connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D51-7 - Body ground | Always | Below 1 Ω |
Connect the spiral cable connector.
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (SPIRAL CABLE - TCM) |
Disconnect the TCM connector.
Disconnect the spiral cable connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A19-1(SFTD) - D51-2 | Always | Below 1 Ω |
| A19-2(SFTU) - D51-1 | Always | Below 1 Ω |
| A19-1(SFTD) or D51-2 - Body ground | Always | 10 kΩ or higher |
| A19-2(SFTU) or D51-1 - Body ground | Always | 10 kΩ or higher |
Connect the TCM connector.
Connect the spiral cable connector.
|
| ||||
| OK | |
| 6.CHECK TRANSMISSION SHIFT SWITCH (TRANSMISSION SHIFT SWITCH - SPIRAL CABLE) |
Disconnect the spiral cable connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| z4-4 - z4-1 | Pull continuously "+" (Up shift) | Below 1 Ω |
| Release "+" or "-" | 10 kΩ or higher | |
| z4-3 - z4-1 | Pull continuously "-" (Down shift) | Below 1 Ω |
| Release "+" or "-" | 10 kΩ or higher |
Connect the spiral cable connector.
|
| ||||
| OK | ||
| ||
| 7.INSPECT TRANSMISSION SHIFT SWITCH ASSEMBLY |
Inspect the transmission shift switch assembly (Click here).
|
| ||||
| OK | ||
| ||