Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM

LIGHTING SYSTEM > Interior Light Circuit

for Preparation Click here


DESCRIPTION

The main body ECU (network gateway ECU) controls the operation of the map light assembly

WIRING DIAGRAM


E249234E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.PERFORM ACTIVE TEST USING GTS
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Body Electrical / Main Body / Active Test.

  1. Check that the lights operate.

    OK:
    Map light fades in.


    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Illuminated Entry System
    Map light assembly
    ON/OFF
    -



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT MAP LIGHT ASSEMBLY
  1. Remove the map light assembly (Click here).

  1. Inspect the map light assembly (Click here).

    OK:
    Map light assembly is normal.



NG
REPLACE MAP LIGHT ASSEMBLY (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (BATTERY - MAP LIGHT ASSEMBLY)
  1. Disconnect the K3 map light assembly connector.



    E249591E01
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    K3-2 (+B) - Body ground
    Always
    11 to 14 V

Text in Illustration 
*a
Front view of wire harness connector
(to map light assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (MAP LIGHT ASSEMBLY - MAIN BODY ECU (NETWORK GATEWAY ECU))
  1. Disconnect the K3 map light assembly connector.

  1. Disconnect the D5 main body ECU (network gateway ECU) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K3-3 (DOOR SW) - D5-7 (DOMR)
    Always
    Below 1 Ω
    D5-7 (DOMR) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (NETWORK GATEWAY ECU) (Click here)