Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Tachometer Malfunction

for Preparation Click here


DESCRIPTION

The combination meter assembly controls the tachometer in accordance with the engine speed signals from the ECM through the CAN communication system.

WIRING DIAGRAM


E140490E61


INSPECTION PROCEDURE

1.CHECK FOR DTC (METER / GAUGE SYSTEM)
  1. Check if meter gauge system DTCs are output (Click here).

    OK:
    DTCs are not output.



NG
GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
OK


2.CHECK FOR DTC (SFI SYSTEM)
  1. Check if the SFI system outputs DTCs (Click here).

    OK:
    DTCs are not output.



NG
GO TO SFI SYSTEM (Click here)
OK


3.PERFORM ACTIVE TEST USING GTS (TACHOMETER OPERATION)
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  1. According to the display on the tester, perform the Active Test.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Tachometer Operation
    Tachometer
    0, 1000, 2000, 3000, , 4000, 5000, 6000, 7000 rpm
    -

    OK:
    The engine speed displayed on the tester is approximately the same as that of the tachometer reading.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE ECM (Click here)