Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Engine Coolant Temperature Receiver Gauge Malfunction

for Preparation Click here


DESCRIPTION

The combination meter assembly controls the engine coolant temperature receiver gauge in accordance with the engine coolant temperature sensor signals from the ECM through the CAN communication system.

WIRING DIAGRAM


E140490E46


INSPECTION PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if CAN communication DTCs are output (Click here).
    Result 
    Result
    Proceed to
    DTCs are not output
    A
    DTCs are output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.PERFORM ACTIVE TEST USING GTS (WATER TEMPERATURE METER OPERATION)
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  1. According to the display on the tester, perform the Active Test.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Water Temperature Meter Operation
    Water temperature gauge
    LOW, NORMAL, HIGH
    Vehicle is stopped and engine is idling

    OK:
    The value selected during Active Test is displayed.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK


3.READ VALUE USING GTS (COOLANT TEMPERATURE)
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Body Electrical / Combination Meter / Data List.

  1. According to the display on the tester, read the Data List.

    Combination Meter 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Coolant Temperature
    Engine coolant temperature
    Min.: 0 (0)
    Max.: 127.5 (261.5)
    After warming up: 80 to 108 (176 to 226)
    Unit: °C ( °F)

    OK:
    The vehicle's coolant temperature and tester value are the same.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK


4.CHECK SFI SYSTEM
  1. Check if the SFI system outputs DTCs (Click here).
    Result 
    Result
    Proceed to
    DTCs are not output
    A
    DTCs are output
    B



B
GO TO SFI SYSTEM (Click here)
A


5.READ VALUE USING GTS (COOLANT TEMP)
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List.

  1. According to the display on the tester, read the Data List.

    Engine and ECT 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Coolant Temp
    Coolant temperature
    Min.: -40 (-40)
    Max.: 215 (419)
    After warming up: 75 to 100 (167 to 212)
    Unit: °C ( °F)

    OK:
    The vehicle's coolant temperature and tester value are the same.



NG
GO TO SFI SYSTEM (Click here)
OK


6.REPLACE COMBINATION METER ASSEMBLY
  1. Replace the combination meter assembly with a new or a normal one (Click here).

OK:
The operation of the engine coolant temperature returns to normal.



NG
REPLACE ECM (Click here)
OK

END