Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Engine Coolant Temperature Receiver Gauge Malfunction

for Preparation Click here


DESCRIPTION

The combination meter assembly controls the engine coolant temperature receiver gauge in accordance with the engine coolant temperature sensor signals from the ECM through the CAN communication system.

WIRING DIAGRAM


E140490E62


INSPECTION PROCEDURE

1.CHECK FOR DTC (METER / GAUGE SYSTEM)
  1. Check if meter / gauge system DTCs are output (Click here).

    OK:
    DTCs are not output.



MG
GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
A


2.CHECK FOR DTC (SFI SYSTEM)
  1. Check if the SFI system DTCs are output (Click here).

    OK:
    DTCs are not output.



NG
GO TO SFI SYSTEM (Click here)
OK


3.PERFORM ACTIVE TEST USING GTS (WATER TEMPERATURE METER OPERATION)
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  1. According to the display on the tester, perform the Active Test.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Water Temperature Meter Operation
    Water temperature gauge
    LOW, NORMAL, HIGH
    Vehicle is stopped and engine is idling

    OK:
    The value selected during Active Test is displayed.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE ECM (Click here)