Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1234    Yaw Rate Sensor

DTC    C1419    Acceleration Sensor Internal Circuit

DTC    C1472    Acceleration Sensor

DTC    C1474    Forward and Rearward G Sensor

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
C1234
Internal failure of the skid control ECU (Yaw rate sensor).
Skid control ECU (Brake actuator assembly)
C1419
Internal failure of the skid control ECU (Acceleration sensor).
C1472
Internal failure of the skid control ECU (Lateral G sensor).
C1474
Internal failure of the skid control ECU (Forward and backward G sensor).

INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU (brake actuator assembly), perform VSC sensor neutral memorization (Click here).

1.CHECK BRAKE ACTUATOR ASSEMBLY INSTALLATION
  1. Turn the ignition switch off.

  1. Check that the skid control ECU (brake actuator assembly) has been installed properly (Click here).

    OK:
    The skid control ECU (brake actuator assembly) should be tightened to the specified torque.
    The skid control ECU (brake actuator assembly) should not be tilted.



NG
INSTALL BRAKE ACTUATOR ASSEMBLY CORRECTLY (Click here)
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)