Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

DTC    C1581    Assist Map Number Un-Writing

for Preparation Click here


DESCRIPTION

The power steering ECU assembly stores this DTC when it determines that the assist map is not written in the ECU.

HINT:
The assist map is data written in the power steering ECU assembly to control the degree of power assist. The assist map is selected based on the vehicle's specified communication data.


DTC Code
DTC Detection Condition
Trouble Area
C1581
The assist map is not written in the power steering ECU assembly.
  1. assist map not written
  2. CAN communication system
  3. ECM
  4. Power steering ECU assembly

INSPECTION PROCEDURE

NOTICE:
If the power steering ECU assembly is replaced with a new one, perform rotation angle sensor initialization and torque sensor zero point calibration (Click here).

1.INITIALIZE ROTATION ANGLE SENSOR AND CALIBRATE TORQUE SENSOR ZERO POINT
  1. Initialize the rotation angle sensor and calibrate the torque sensor zero point (Click here).

    HINT:
    The assist map is automatically written during the rotation angle sensor initialization and torque sensor zero point calibration.


NEXT


2.CHECK FOR DTC
  1. Check for DTCs (Click here).

    OK:
    DTC C1581 is not output.

    HINT:
    DTC C1581 is cleared after the assist map is written.



NG
Go to step 3
OK

END 

3.CHECK FOR DTC (CAN COMMUNICATION SYSTEM)
  1. Using the GTS, check for DTCs and confirm that there are no problems in the CAN communication system (Click here).

    OK:
    DTC is not output.



NG
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
OK


4.CHECK ECM
  1. Check if an ECM that complies with the vehicle specifications is installed.



NG
REPLACE ECM (Click here)
OK

REPLACE POWER STEERING ECU ASSEMBLY (Click here)