Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (except LHD M/T)

BRAKE PEDAL (except LHD M/T) > INSTALLATION

for Preparation Click here



1. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY
  1. Install the brake pedal support assembly with the 4 nuts.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }

  1. Install the brake pedal support assembly with the 2 bolts.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }



2. INSTALL PUSH ROD PIN


    C264102E01
  1. Apply lithium soap base glycol grease to the push rod pin.
    Text in Illustration 
    *1
    Push Rod Pin
    V100145
    Lithium Soap Base Glycol Grease

  1. Connect the brake master cylinder push rod clevis to the brake pedal support assembly with the push rod pin, and install a new clip as shown in the illustration.

    NOTICE:
    After installation, check that the pedal operates smoothly.



3. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER
  1. Engage the 2 claws and install the stop light switch mounting adjuster.



4. INSPECT AND ADJUST BRAKE PEDAL
(Click here)


5. INSPECT AND ADJUST BRAKE PEDAL HEIGHT



6. INSPECT BRAKE PEDAL FREE PLAY



7. INSPECT BRAKE PEDAL RESERVE DISTANCE



8. INSTALL STOP LIGHT SWITCH ASSEMBLY
(Click here)


9. INSTALL TCM (for Automatic Transmission)
(Click here)


10. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)
(Click here)


11. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)
  1. Connect each connector.



    B312545E01
  1. for Automatic Air Conditioning System for RHD:

    1. Connect the connector.

    2. Engage the guide and connect the aspirator hose.
      Text in Illustration 
      *1
      Aspirator Hose

  1. Engage the 4 claws.

  1. Engage the 4 clips to install the No. 1 instrument panel under cover sub-assembly.

  1. Install the 2 screws.



12. INSTALL INSTRUMENT SIDE PANEL LH (w/o Knee Airbag)

HINT:
Use the same procedure for the LH side as for the RH side