Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR

REAR STABILIZER BAR > INSTALLATION

for Preparation Click here



1. INSTALL REAR STABILIZER BAR BUSHING (for LH Side)


    C262301E01
  1. Install the rear stabilizer bar bushing to the outside of the stopper ring on the rear stabilizer bar as shown in the illustration.
    Text in Illustration 
    *1
    Rear Stabilizer Bar Bushing
    *a
    Stopper Ring



2. INSTALL REAR STABILIZER BAR BUSHING (for RH Side)

HINT:
Use the same procedure described for the LH side.



3. INSTALL REAR STABILIZER BAR
  1. Install the rear stabilizer bar to the rear suspension member.



4. INSTALL REAR STABILIZER BRACKET (for LH Side)


    C256609E01
  1. Install the rear stabilizer bracket with the 2 bolts.
    Text in Illustration 
    *a
    Crow

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }

    NOTICE:
    Install the rear stabilizer bracket with its claw facing upper.



5. INSTALL REAR STABILIZER BRACKET (for RH Side)

HINT:
Use the same procedure described for the LH side.



6. INSTALL STABILIZER LINK SUB-ASSEMBLY (for LH Side)
  1. Install the rear stabilizer link sub-assembly to the rear stabilizer bar

  1. Using a socket hexagon 5 mm, hold the stud bolt and tighten the nut.

    Torque:
    38 N*m{ 388 kgf*cm , 28 ft.*lbf }

  1. Temporarily install the rear stabilizer link sub-assembly to the rear No. 2 suspension arm assembly LH with the bolt and a new nut.



7. INSTALL STABILIZER LINK SUB-ASSEMBLY (for RH Side)

HINT:
Use the same procedure described for the LH side.



8. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ HID Headlight System)
  1. Install the rear height control sensor sub-assembly LH to the rear No. 2 suspension arm assembly LH with the nut.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



9. INSTALL REAR WHEELS

Torque:
120 N*m{ 1224 kgf*cm , 89 ft.*lbf }



10. STABILIZE SUSPENSION


11. FULLY TIGHTEN STABILIZER LINK SUB-ASSEMBLY (for LH Side)
  1. Install the rear stabilizer link sub-assembly to the rear No. 2 suspension arm assembly LH with the bolt and nut.

    Torque:
    38 N*m{ 388 kgf*cm , 28 ft.*lbf }



12. FULLY TIGHTEN STABILIZER LINK SUB-ASSEMBLY (for RH Side)

HINT:
Use the same procedure described for the LH side.



13. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
(Click here)


14. VSC SENSOR NEUTRAL MEMORIZATION
(Click here)


15. HEIGHT CONTROL SENSOR SIGNAL INITIALIZE (w/ HID Headlight System)
(Click here)


16. ADJUST HEADLIGHT AIMING (w/ HID Headlight System)
(Click here)