Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

DTC    C1582    Assist Map Number Mismatch

for Preparation Click here


DESCRIPTION

If an incorrect power steering ECU assembly or ECM or skid control ECU is installed, DTC C1582 is stored as the vehicle specification and data do not match.

HINT:
The assist map is data written in the power steering ECU assembly to control the degree of assistance. The assist map is selected based on the vehicle's specified communication data.


DTC Code
DTC Detection Condition
Trouble Area
C1582
Data that does not match the vehicle specification is received through CAN communication.
  1. CAN communication system
  2. ECM (wrong assembly)
  3. Skid control ECU (wrong assembly)
  4. Power steering ECU assembly (wrong assembly)

INSPECTION PROCEDURE

NOTICE:
If the power steering ECU assembly is replaced with a new one, perform rotation angle sensor initialization and torque sensor zero point calibration (Click here).

1.CHECK FOR DTC (CAN COMMUNICATION SYSTEM)
  1. Using the GTS, check for DTCs and confirm that there are no problems in the CAN communication system (Click here).

    OK:
    DTC is not output.



NG
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
OK


2.CHECK ECM
  1. Check if an ECM that complies with the vehicle specifications is installed.



NG
REPLACE ECM (Click here)
OK


3.CHECK SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY)
  1. Check if a skid control ECU (brake actuator assembly) that complies with the vehicle specifications is installed.



NG
REPLACE SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY) (Click here)
OK

REPLACE POWER STEERING ECU ASSEMBLY (Click here)