FRONT LOWER SUSPENSION ARM > INSTALLATION |
| 1. INSTALL FRONT LOWER SUSPENSION ARM BOLT |
Using SST, install the new front lower suspension arm bolt.
| 2. TEMPORARILY TIGHTEN FRONT LOWER SUSPENSION ARM ASSEMBLY LH |
Temporarily tighten the front lower suspension arm assembly LH with the bolt and new nut.
| 3. INSTALL STEERING KNUCKLE LH |
Install the front lower arm suspension arm assembly LH with the nut to the steering knuckle LH.
Install new clip.
| 4. INSTALL TIE ROD END SUB-ASSEMBLY LH |
Install the nut and the tie rod sub-assembly LH to the steering knuckle LH.
Install a new cotter pin.
| 5. INSTALL LOWER ARM SUPPORT PLATE |
Install the lower arm support plate with the new bolt and new nut.
| 6. INSTALL FRONT WHEEL |
| 7. STABILIZE SUSPENSION |
Lower the vehicle and bounce it up and down several times to stabilize the front suspension.
| 8. FULLY TIGHTEN FRONT LOWER SUSPENSION ARM ASSEMBLY LH |
Fully tighten the nut on the rear of the front lower suspension arm assembly LH.
| 9. INSTALL REAR ENGINE UNDER COVER LH |
Install the rear engine under cover LH with the 3 clips.
| 10. INSPECT STEERING WHEEL CENTER POINT |
| 11. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |
| 12. VSC SENSOR NEUTRAL MEMORIZATION |
| 13. HEIGHT CONTROL SENSOR SIGNAL INITIALIZE (w/ HID Headlight System) |
| 14. ADJUST HEADLIGHT AIMING (w/ HID Headlight System) |