Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/o Entry and Start System)

DTC    B1571    Immobiliser Key Check NG

for Preparation Click here


DESCRIPTION

The ECM stores this code if the main body ECU (network gateway ECU) reference code and the reference code from the ECM do not match.

DTC Code
DTC Detection Condition
Trouble Area
B1571
The main body ECU (network gateway ECU) reference code and reference code from the ECM do not match.
  1. ECM
  2. Main body ECU (network gateway ECU)

INSPECTION PROCEDURE

NOTICE:
If the main body ECU (network gateway ECU) or ECM is replaced, refer to Service Bulletin.

1.READ VALUE USING GTS (NUMBER OF REGISTRATION KEY)
  1. Connect GTS to DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Body Electrical / Main Body / Data List.

  1. According to the display on the GTS, read the Data List.


Main Body 
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Number of Registration Key
Number of registered key/ min. 0, max. 8
Number of registered key
-
Result 
Result
Proceed to
The registered number of the key is 0.
A
The registered number of the key is 1 or more.
B


B
Go to step 3
A


2.REGISTER KEY
  1. Reregister the key (Refer to Service Bulletin).

OK:
The key ID can be registered.



NG
Go to step 4
OK

END 

3.REGISTER ECU COMMUNICATION ID
  1. Register the ECU communication ID (Refer to Service Bulletin).

OK:
The ECU communication ID can be registered



NG
Go to step 4
OK

END 

4.CHECK FOR DTC
  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC B1571 is output
    A
    Other than DTC B1571 are output
    B



B
GO TO DTC CHART (Click here)
A


5.REPLACE ECM
  1. Temporarily replace the ECM with a new or known good one (Click here).


NEXT


6.REGISTER ECU COMMUNICATION ID
  1. Register the ECU communication ID (Refer to Service Bulletin).

OK:
The ECU communication ID can be registered



NG
REPLACE MAIN BODY ECU (NETWORK GATEWAY ECU) (Click here)
OK

END