Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM

DTC    C2198/98    Initialization Switch (for Test Mode DTC)

for Preparation Click here


DESCRIPTION

During test mode, when the tire pressure warning reset switch is on, the tire pressure warning light comes on and when the tire pressure warning reset switch is off, the tire pressure warning light blinks at 0.125 second intervals.

DTC No.
DTC Detection Condition
Trouble Area
C2198/98
Test mode procedure is performed.
  1. Tire pressure warning reset switch
  2. Wire harness or connector
  3. Tire pressure warning ECU and receiver

WIRING DIAGRAM


C305302E02


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.
  2. It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU after the ECU has been replaced.

1.INSPECT TIRE PRESSURE WARNING RESET SWITCH
  1. Remove the tire pressure warning reset switch (Click here).

  1. Inspect the tire pressure warning reset switch (Click here).



NG
REPLACE TIRE PRESSURE WARNING RESET SWITCH (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (RESET SWITCH - TIRE PRESSURE WARNING ECU AND RECEIVER)
  1. Disconnect the tire pressure warning reset switch D76 connector and tire pressure warning ECU and receiver H28 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H28-3 (CLSW) - D76-6
    Always
    Below 1 Ω
    H28-3 (CLSW) - Body ground
    Always
    10 kΩ or higher
    D76-3 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER (Click here)