DTC P2270 Oxygen Sensor Signal Stuck Lean (Bank 1 Sensor 2) |
DTC P2271 Oxygen Sensor Signal Stuck Rich (Bank 1 Sensor 2) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P2270 | Heated oxygen sensor voltage is less than 0.55 V for 15 seconds or more. (2 trip detection logic) |
|
| P2271 | Heated oxygen sensor voltage is more than 0.15 V for 0.5 seconds or more. (2 trip detection logic) |

| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK ANY OTHER DTCS OUTPUT |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read DTCs.
| Result | Proceed to |
| P2270 or P2271 is output | A |
| P2270 or P2271 and other DTCs are output | B |
|
| ||||
| A | |
| 2.CHECK CONNECTOR (HEATED OXYGEN SENSOR) |
Disconnect the heated oxygen sensor connector and intermediate connector.
Check for water intrusion into each connector.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (HEATED OXYGEN SENSOR - ECM) |
Disconnect the heated oxygen sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C13-1 (HT1B) - A36-6 (HT1B) | Always | Below 1 Ω |
| C13-3 (OX1B) - A34-21 (OX1B) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| C13-1 (HT1B) or A36-6 (HT1B) - Body ground | Always | 10 kΩ or higher |
| C13-3 (OX1B) or A34-21 (OX1B) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (HEATED OXYGEN SENSOR - ECM) |
Disconnect the heated oxygen sensor connector.
Reconnect the ECM connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| C13-3 (OX1B) - Body ground | Ignition switch ON | Below 1.5 V |
|
| ||||
| OK | |
| 5.CHECK FOR EXHAUST GAS LEAK |
Inspect for exhaust gas leaks from the exhaust manifold sub-assembly and exhaust pipes.
|
| ||||
| OK | |
| 6.REPLACE HEATED OXYGEN SENSOR |
Replace the heated oxygen sensor (Click here).
| NEXT | |
| 7.CHECK WHETHER DTC OUTPUT RECURS |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Clear the DTCs (Click here).
Turn the ignition switch off and wait for at least 30 seconds.
Turn the ignition switch to ON.
Turn the Techstream on.
Start the engine and warm it up.
Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern.
Enter the following menus: Powertrain / Engine / Trouble Codes.
| Result | Proceed to |
| DTC is not output | A |
| DTC P2270 or P2271 is output | B |
|
| ||||
| A | ||
| ||