Home › Engine / Hybrid System › FA20 (ENGINE CONTROL) › SFI SYSTEM › 2012.03–2016.06
RM2090E _51 Engine / Hybrid System _060665 FA20 ENGINE CONTROL _0297470 SFI SYSTEM J

FA20 ENGINE CONTROL  SFI SYSTEM  MIL Circuit  


DESCRIPTION

The MIL (Malfunction Indicator Lamp) is used to indicate vehicle malfunctions detected by the ECM. When the ignition switch is turned to ON, power is supplied to the MIL circuit, which illuminates the MIL.

The MIL operation can be checked visually: When the ignition switch is turned to ON, the MIL should be illuminated and should turn off after engine is started. If the MIL remains illuminated or is not illuminated, conduct the following troubleshooting procedure using the GTS.

WIRING DIAGRAM

A397709E01
2.563,0.74 2.719,0.938 0.156,0.198 10 false 6 2.552,1.438 2.708,1.635 0.156,0.198 10 false 7 4.5,1.417 4.656,1.615 0.156,0.198 10 false 18 4.5,0.74 4.656,0.938 0.156,0.198 10 false 19 4.76,0.875 5.177,1.063 0.417,0.188 10 false CANH 4.781,1.573 5.198,1.76 0.417,0.188 10 false CANL 0.76,2.135 1.021,2.323 0.26,0.188 10 false D7 0.76,2.313 2.75,2.552 1.99,0.24 10 false Combination Meter Assembly 1.01,3.406 3,3.646 1.99,0.24 10 false : CAN Communication Line 4.771,2.146 5.188,2.333 0.417,0.188 10 false A33 4.771,2.333 5.396,2.594 0.625,0.26 10 false ECM

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK THAT MIL IS ILLUMINATED
a.

Perform troubleshooting in accordance with the table below.

Result
Result Proceed to
MIL remains ON A
MIL does not illuminate B
MIL illuminates for several seconds, but turns off after engine is started C



A

2.CHECK WHETHER MIL TURNS OFF

B

3.CHECK THAT ENGINE STARTS

C

2.CHECK WHETHER MIL TURNS OFF
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine / Trouble Codes.


e.

Check if any DTCs have been detected. Note down any DTCs.

Result
Result Proceed to
No DTC detected A
Any DTCs detected B

HINT:

Check for detected DTCs output from other ECUs which relate to the MIL.




A

B

REPAIR CIRCUITS INDICATED BY OUTPUT DTCS

3.CHECK THAT ENGINE STARTS
a.

Turn the ignition switch to ON.


b.

Start the engine.

Result
Result Proceed to
Engine starts A
Engine does not start* B

HINT:

*: The GTS cannot communicate with the ECM.




A

B