Home › Engine / Hybrid System › FA20 FUEL › FUEL PRESSURE SENSOR › 2012.03–2016.06
RM2090E _51 Engine / Hybrid System _060667 FA20 FUEL _0297502 FUEL PRESSURE SENSOR A

FA20 FUEL  FUEL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89458 1.INSTALL FUEL PRESSURE SENSOR

a.
A282919E01
0.327,0.916 0.614,1.097 0.287,0.181 10 SST 0.683,1.009 1.29,1.117 false

Using SST, install the new fuel pressure sensor to the No. 1 fuel delivery pipe sub-assembly RH.

SST
09922-10010  

Torque:
Without SST : 36 N*m (367 kgf*cm, 27 ft.*lbf)
With SST : 32 N*m (326 kgf*cm, 24 ft.*lbf)

NOTICE:
·

Ensure that no oil adheres to the threads of the fuel pressure sensor and No. 1 fuel delivery pipe sub-assembly RH.

·

Do not allow foreign objects to enter when assembling the fuel pressure sensor.



HINT:
·

Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


·

Make sure SST and the wrench are connected in a straight line.




b.

Connect the fuel pressure sensor connector.