Home › Engine / Hybrid System › FA20 EMISSION CONTROL › EMISSION CONTROL SYSTEM
RM2090E _51 Engine / Hybrid System _060668 FA20 EMISSION CONTROL _0297509 EMISSION CONTROL SYSTEM G

FA20 EMISSION CONTROL  EMISSION CONTROL SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 17650 1.CHECK PURGE VALVE

a.
A280932E02
1.844,1.354 1.656,1.927 true 1.677,0.563 1.927,1.177 true 1.583,1.958 1.74,2.135 0.156,0.177 10 false *2 1.594,0.396 1.75,0.573 0.156,0.177 10 false *1

Disconnect the No. 2 fuel vapor feed hose (on the canister side) of the fuel pipe.

Text in Illustration
*1 Fuel delivery pipe sub-assembly
*2 No.2 fuel vapor feed hose


b.

Connect the GTS to the DLC3.


c.

Start the engine.


d.

Turn the GTS on.


e.

Enter the following menus: Engine / Active Test / Activate the VSV for Evap Control.


f.

When the purge valve is operated using the tester, check whether the port of the purge valve applies suction to your finger.

OK:
Tester Operation Specified Condition
Check valve: OFF Purge valve has no suction
Check valve: ON Purge valve has suction


If the result is not as specified, check the valve (See page Engine / Hybrid System>FA20 EMISSION CONTROL>PURGE VALVE>INSPECTION), wire harness and ECM.


g.

Connect the No. 2 fuel vapor feed hose (on the canister side) of the purge valve.


Hide 2.INSPECT FUEL CUT-OFF RPM

a.

Start and warm up the engine.


b.

Use a sound scope to check for injector operation noise.


c.

Increase the engine speed to at least 3000 rpm.


d.

Check that when the accelerator pedal is released, the injector operation noise stops momentarily and then resumes.

Standard:
Item Specified Condition
Fuel cut off rpm 2500 rpm or more
Fuel injection restart rpm 1400 rpm


If the result is not as specified, check the injector (See page Engine / Hybrid System>FA20 FUEL>FUEL INJECTOR(for Port Injection)>INSPECTION), wire harness and ECM.


Hide 3.VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS EMISSION HOSE

a.
A280933

Check that there are no cracks, leaks or damage.

NOTICE:
·

Detachment or other problems with the engine oil dipstick, filler cap, ventilation hose and other components may cause the engine to run improperly.

·

Air suction caused by disconnections, looseness or cracks in the parts of the air induction system between the throttle body and cylinder head will cause engine failure or engine malfunctions.



If the result is not as specified, replace parts as necessary.


Hide 4.CHECK HOSES AND CONNECTORS

a.

Visually check for loose connections, sharp bends or damage.