41110
1.REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY
51206A
2.REMOVE REAR SUSPENSION MEMBER SUB-ASSEMBLY
77740S
3.REMOVE CANISTER PUMP MODULE (for Metal Type)
Disconnect the drain hose B as indicated by the arrows, in the order shown in the illustration.
Disconnect the drain hose A as indicated by the arrows, in the order shown in the illustration.
Disconnect the evaporation hose from the fuel filler pipe assembly.
Disengage the clip.
Remove the 3 bolts and check valve.
Disengage the clip.
Disengage the clamp.
Remove the nut and bracket B.
Remove the 2 nuts and bracket A.
Disconnect the drain hose A and drain hose B as indicated by the arrows, in the order shown in the illustration.
| *1 | Drain hose A |
| *2 | Drain hose B |
Disconnect the 2 quick connector as indicated by the arrows, in the order shown in the illustration, and remove the drain hose E.
77740
4.REMOVE CHARCOAL CANISTER ASSEMBLY (for Metal Type)
Disconnect the drain hose D as indicated by the arrows, in the order shown in the illustration.
Disconnect the drain hose C as indicated by the arrows, in the order shown in the illustration.
Remove the nut.
Remove the 2 bolts and charcoal canister assembly along with the canister base bracket B.
Remove the 2 nuts and canister base bracket.
77720H
5.REMOVE FUEL OUTLET VALVE ASSEMBLY (for Clamp Type)
Disconnect the evaporation hose from the fuel outlet valve assembly.
| *1 | Evaporation hose |
| *2 | Drain hose |
Disengage the hose clamp, and disconnect the evaporation hose and drain hose.
Disengage the clamp, and remove the fuel outlet valve assembly.
6.REMOVE CHARCOAL CANISTER ASSEMBLY (for Clamp Type)
Disengage the 3 hose clamps, and disconnect the drain hose and drain tube.
| *1 | Drain hose |
| *2 | Drain tube |
Disconnect the purge tube.
Remove the 2 bolts and nut, and remove the charcoal canister assembly with canister bracket A and canister bracket B.
Remove the 3 nuts, canister bracket A, and canister bracket B.
| *1 | Canister bracket A |
| *2 | Canister bracket B |