Home › Drivetrain › TX6A (AUTOMATIC TRANSMISSION / TRANSAXLE) › SHIFT LEVER
RM2090E _52 Drivetrain _060674 TX6A AUTOMATIC TRANSMISSION / TRANSAXLE _0297548 SHIFT LEVER N

TX6A AUTOMATIC TRANSMISSION / TRANSAXLE  SHIFT LEVER  ADJUSTMENT  


PROCEDURE

Hide 17410 1.REMOVE FRONT EXHAUST PIPE ASSEMBLY

Hide 2.ADJUST SHIFT LEVER POSITION

a.

While pushing the shift lock release button, move the shift lever to N.


b.
C257566

Using tape, hold a 0.3 mm feeler gauge on the floor shift control select lever.


c.
C257565

Using tape, attach the floor shift control select lever to the console box assembly.

NOTICE:

Make sure that the feeler gauge is not on the area shown in the illustration.



d.
C260577

Remove the nut and disconnect the floor shift gear shifting rod sub-assembly.


e.
C116831E01
1.866,0.104 2.035,0.265 0.170,0.161 10 N 1.573,0.13 1.743,0.290 0.170,0.161 10 R 1.152,0.226 1.322,0.387 0.170,0.161 10 P

Turn the transmission control shaft lever RH of the park/neutral position switch assembly counterclockwise until it stops, and turn it clockwise 2 notches to set it to the N position.


f.
C260577

Temporarily install the floor shift gear shifting rod sub-assembly with the nut.


g.

Tighten the nut while lightly pushing the lever rearward.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)

NOTICE:

Do not push the lever too hard.



Hide 17410 3.INSTALL FRONT EXHAUST PIPE ASSEMBLY

Hide 5.INSPECT FOR EXHAUST GAS LEAK