Home › Drivetrain › CLUTCH › CLUTCH MASTER CYLINDER(for LHD)
RM2090E _52 Drivetrain _060675 CLUTCH _0297562 CLUTCH MASTER CYLINDER(for LHD) A

CLUTCH  CLUTCH MASTER CYLINDER(for LHD)  INSTALLATION  


PROCEDURE

Hide 31481 1.INSTALL CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE

a.

Install the master cylinder to release cylinder hose to the clutch flexible hose bracket with the clip.


b.

Using a union nut wrench (10 mm), connect the clutch master cylinder to flexible hose tube to the master cylinder to release cylinder hose.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



c.

Using a union nut wrench (10 mm), connect the clutch master cylinder to flexible hose tube to the clutch master cylinder assembly.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 31410 2.INSTALL CLUTCH MASTER CYLINDER ASSEMBLY

a.

Install the sheet to the clutch master cylinder assembly.


b.

Install the clutch master cylinder assembly with the 2 nuts.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)


c.

Install the master cylinder to release cylinder hose with a union bolt and 2 new gaskets.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)


Hide 31453 3.INSTALL CLUTCH MASTER CYLINDER PUSH ROD CLEVIS

a.

Apply MP grease to the new clevis pin.


b.

Install the clutch master cylinder push rod clevis to the clutch pedal lever sub-assembly with the clevis pin and a clip.

HINT:

Install the clevis pin from the left side of the vehicle.



Hide 4.FILL UP FILL CLUTCH FLUID

Hide 6.INSPECT FOR CLUTCH FLUID LEAK

Hide 8.INSPECT AND ADJUST CLUTCH PEDAL

Hide 53608 9.INSTALL FRONT SUSPENSION UPPER TO COWL BRACE SUB-ASSEMBLY LH

Hide 73900 10.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)

Hide 73900 11.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)

Hide 55318C 12.INSTALL INSTRUMENT SIDE PANEL LH (w/o Knee Airbag)