Home › Drivetrain › CLUTCH › CLUTCH MASTER CYLINDER(for LHD)
RM2090E _52 Drivetrain _060675 CLUTCH _0297562 CLUTCH MASTER CYLINDER(for LHD) A

CLUTCH  CLUTCH MASTER CYLINDER(for LHD)  REMOVAL  


PROCEDURE

Hide 55318C 2.REMOVE INSTRUMENT SIDE PANEL LH (w/o Knee Airbag)

Hide 55606 3.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)

Hide 73900 4.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)

Hide 5.REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS

a.
C263939

Remove the clip and the clevis pin, and separate the clutch master cylinder push rod clevis from the clutch pedal lever sub-assembly.


Hide 53608 6.REMOVE FRONT SUSPENSION UPPER TO COWL BRACE SUB-ASSEMBLY LH

Hide 31410 7.REMOVE CLUTCH MASTER CYLINDER ASSEMBLY

a.
C258503

Remove the union bolt, 2 gaskets and the master cylinder to the release cylinder hose from the clutch release cylinder assembly.

HINT:

Use a container to collect the fluid.



b.
C262633

Remove the 2 nuts and the clutch master cylinder assembly and sheet.


Hide 31481 8.REMOVE CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE

C262744

a.

Using a union nut wrench (10 mm), disconnect the clutch master cylinder to flexible hose tube from the master cylinder to release cylinder hose.

HINT:

Use a container to collect the fluid.



b.

Remove the clip and the clutch flexible hose bracket.


c.

Using a union nut wrench (10 mm), remove the clutch master cylinder to flexible hose tube from the clutch master cylinder assembly.

HINT:

Use a container to collect the fluid.