Home › Drivetrain › CLUTCH › CLUTCH PEDAL SWITCH(for LHD)
RM2090E _52 Drivetrain _060675 CLUTCH _0297566 CLUTCH PEDAL SWITCH(for LHD) A

CLUTCH  CLUTCH PEDAL SWITCH(for LHD)  INSTALLATION  


PROCEDURE

Hide 84520 1.INSTALL CLUTCH START SWITCH ASSEMBLY

a.

Install the clutch start switch assembly to the clutch pedal support sub-assembly with the nut.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


b.

Connect the clutch start switch connector.


c.
C263918E01
2.084,0.108 2.245,0.279 0.161,0.171 10 *a

With the clutch pedal fully depressed, check that the clearance shown in the illustration is as specified.

Text in Illustration
*a Clearance

Standard clearance:

3.5 to 4.0 mm (0.138 to 0.157n.)


HINT:

Do not turn the clutch start switch assembly.



Hide 55107A 2.INSTALL CLUTCH PEDAL SUPPORT SUB-ASSEMBLY

Hide 88280A 3.INSTALL CLUTCH SWITCH ASSEMBLY

a.

Install the clutch switch assembly to the clutch pedal support sub-assembly with the nut.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


b.

Connect the clutch switch connector.


c.
C262743E01
2.271,1.939 2.445,2.099 0.174,0.160 10 *a

Without depressing the clutch pedal, check that there is no clearance between the switch shaft and the clutch pedal stopper.

Text in Illustration
*a No Clearance

HINT:

Do not turn the clutch switch assembly.



Hide 73900 4.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)

Hide 55606 5.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)

Hide 55318C 6.INSTALL INSTRUMENT SIDE PANEL LH (w/o Knee Airbag)