Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
43502C
1.INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH
Install the front axle hub sub-assembly to the steering knuckle with the 4 new bolts.
Do not allow any foreign matter such as dirt or dust to enter between the steering knuckle.
Do not allow any foreign matter such as dirt or dust to enter between the front axle hub sub-assembly.
2.INSPECT FRONT AXLE HUB BEARING LOOSENESS
3.INSPECT FRONT AXLE HUB RUNOUT
89543
4.INSTALL FRONT SPEED SENSOR LH
Install the bolt and speed sensor front to the steering knuckle.
Do not allow any foreign matter such as dirt or dust to enter between the steering knuckle and the front disc brake dust cover.
43512
5.INSTALL FRONT DISC
47710A
6.INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY
7.INSTALL FRONT WHEEL
8.INSPECT SPEED SENSOR SIGNAL