Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
42450B
1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH
Install the rear axle hub and bearing assembly to the rear axle assembly with the 4 bolts.
42431
2.INSTALL REAR DISC
47810A
3.INSTALL REAR CALIPER ASSEMBLY
42312B
4.INSTALL REAR AXLE SHAFT NUT LH
Clean the threaded parts on the rear drive shaft assembly and a new rear axle shaft nut using a non-residue solvent.
Be sure to perform this step even when using a new rear drive shaft assembly.
Keep the threaded parts free of oil and foreign matter.
Install the new rear axle shaft nut.
Stake the rear axle shaft nut LH after inspecting for looseness and runout in the following steps.
5.INSPECT REAR AXLE HUB BEARING LOOSENESS
6.INSPECT REAR AXLE HUB RUNOUT
42312B
7.STAKE REAR AXLE SHAFT NUT LH
Using a chisel and hammer, stake the rear axle shaft nut LH.
89546
8.INSTALL REAR SPEED SENSOR LH
Install the bolt and the rear speed sensor LH.
9.INSTALL REAR WHEEL
10.ADJUST PARKING BRAKE LEVER TRAVEL
11.INSPECT SPEED SENSOR SIGNAL