Home › Suspension › REAR SUSPENSION › REAR LOWER ARM
RM2090E _53 Suspension _060681 REAR SUSPENSION _0297607 REAR LOWER ARM A

REAR SUSPENSION  REAR LOWER ARM  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

The procedure listed below is for the LH side.

·

Use the same procedure for the RH and LH sides.



PROCEDURE

Hide 48740F 1.TEMPORARILY INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY LH

a.

Temporarily install the rear No. 2 suspension arm assembly to the rear suspension member with the bolt and new nut.

NOTICE:

Insert the bolt from the front side of the vehicle.



b.

Temporarily install the rear No. 2 suspension arm assembly to the axle carrier with the bolt and new nut.

NOTICE:

Insert the bolt from the front side of the vehicle.



Hide 2.TEMPORARILY INSTALL REAR SHOCK ABSORBER WITH COIL SPRING

a.

Temporarily install the rear shock absorber with coil spring to the rear No. 2 suspension arm assembly LH with the bolt and new nut.

HINT:

The bolt may be inserted from either direction.



Hide 48802 3.INSTALL STABILIZER LINK SUB-ASSEMBLY (for LH Side)

Hide 89408C 4.INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ HID Headlight System)

Hide 48720A 5.TEMPORARILY INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY LH

a.

Temporarily install the rear No. 1 suspension arm assembly LH to the axle carrier with the new bolt and new nut.

NOTICE:

Insert the bolt from inside the vehicle.



b.

Temporarily install the rear No. 1 suspension arm assembly LH to the rear suspension member with the new bolt and new nut.

NOTICE:

Insert the bolt from outside the vehicle.



Hide 48740F 7.FULLY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY LH

Hide 48720A 8.FULLY TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY LH

a.

Fully tighten the 2 bolt and 2 nut of the rear No. 1 suspension arm assembly LH.

Torque:
110 N*m (1122 kgf*cm, 81 ft.*lbf)


Hide 46451C 9.INSTALL NO. 1 PARKING BRAKE CABLE SUPPORT BRACKET

a.

Install the No. 1 parking brake cable support bracket with the bolt.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)


Hide 10.INSTALL REAR WHEEL

Torque:
120 N*m (1224 kgf*cm, 89 ft.*lbf)

Hide 11.INSPECT AND ADJUST REAR WHEEL ALIGNMENT

Hide 13. HEIGHT CONTROL SENSOR SIGNAL INITIALIZE (w/ HID Headlight System)

Hide 14.ADJUST HEADLIGHT AIMING (w/ HID Headlight System)