Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM
RM2090E _54 Brake _060684 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0297617 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1201  Engine Control System Malfunction  


DESCRIPTION

If a malfunction in the SFI system is detected, the operation of VSC and TRC is prohibited by the fail-safe function. When the signals from the engine are received normally, fail-safe control is canceled.

DTC No. DTC Detection Condition Trouble Area
C1201 Engine control system malfunction signal continues for 5 seconds while the vehicle is being driven. SFI system

PROCEDURE

1.CHECK SFI SYSTEM
a.

Check if an SFI system DTC is output (See page Engine / Hybrid System>FA20 (ENGINE CONTROL)>SFI SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTC is not output. A
DTC is output. B


HINT:

If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE).




A

B