Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR
RM2090E _54 Brake _060684 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0297618 BRAKE ACTUATOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE ACTUATOR  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

Before removing the brake actuator assembly, refer to the "Brake line precaution". (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE LINE>PRECAUTION)


PROCEDURE

Hide 1.REMOVE FRONT WHEEL LH

Hide 2.DRAIN BRAKE FLUID

NOTICE:

Wash off the brake fluid immediately if it comes into contact with a painted surface.


Hide 53876A 3.REMOVE FRONT FENDER LINER LH

Hide 4.REMOVE BRAKE ACTUATOR ASSEMBLY WITH BRAKE ACTUATOR BRACKET

a.
C257484

Disconnect the harness clamp from the brake actuator bracket.


b.
C257485

Disconnect the harness clamp from the brake actuator bracket.


c.
C257486

Disconnect the cooler pipe from the clamp.


d.
C257471

Disconnect the front speed sensor LH harness clamp from the brake actuator bracket.


e.
C263749E01
2.471,1.788 2.648,1.934 0.177,0.145 10 *a

Press the wire harness connector locking claw to disengage the locking lever, and turn the locking lever upwards to unlock the connector.

Text in Illustration
*a Turn


f.

Disconnect the connector from the brake actuator assembly.


g.
C262299

Using a union nut wrench 12 mm, disconnect the 2 brake lines from the brake actuator assembly.

NOTICE:

Be careful not to allow the brake fluid to enter the removed connector.



h.
C257482

Using a union nut wrench 10 mm, disconnect the 4 brake lines from the brake actuator assembly.

NOTICE:

Be careful not to allow the brake fluid to enter the removed connector.



i.
C257483

Remove the brake actuator bracket installation bolt.


j.
C257487

Remove the 3 bolts from the brake actuator with bracket.


k.

Remove the brake actuator with bracket from the vehicle body.

NOTICE:

Do not damage the brake tubes.