47110
1.INSTALL BRAKE PEDAL SUPPORT ASSEMBLY
Install the brake pedal support assembly with the 4 nuts.
Install the brake pedal support assembly with the 2 bolts.
47264A
2.INSTALL PUSH ROD PIN
Apply lithium soap base glycol grease to the push rod pin.
| *1 | Push Rod Pin |
|
Lithium Soap Base Glycol Grease |
Connect the brake master cylinder push rod clevis to the brake pedal support assembly with the push rod pin, and install a new clip as shown in the illustration.
After installation, check that the pedal operates smoothly.
84345
3.INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER
Engage the 2 claws and install the stop light switch mounting adjuster.
4.INSPECT AND ADJUST BRAKE PEDAL
5.INSPECT AND ADJUST BRAKE PEDAL HEIGHT
6.INSPECT BRAKE PEDAL FREE PLAY
7.INSPECT BRAKE PEDAL RESERVE DISTANCE
84340
8.INSTALL STOP LIGHT SWITCH ASSEMBLY
89071B
9.INSTALL TCM (for Automatic Transmission)
10.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)
55606
11.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)
55318C
12.INSTALL INSTRUMENT SIDE PANEL LH (w/o Knee Airbag)
Use the same procedure for the LH side as for the RH side (See page Vehicle Exterior>WINDOW / GLASS>FRONT PASSENGER SIDE POWER WINDOW SWITCH>REMOVAL)