Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › 2012.03–2015.04
RM2090E _55 Steering _060689 POWER ASSIST SYSTEMS _0297642 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1582  Assist Map Number Mismatch  


DESCRIPTION

If an incorrect power steering ECU assembly or ECM or skid control ECU is installed, DTC C1582 is stored as the vehicle specification and data do not match.

HINT:

The assist map is data written in the power steering ECU assembly to control the degree of assistance. The assist map is selected based on the vehicle's specified communication data.


DTC Code DTC Detection Condition Trouble Area
C1582 Data that does not match the vehicle specification is received through CAN communication.
·

CAN communication system

·

ECM (wrong assembly)

·

Skid control ECU (wrong assembly)

·

Power steering ECU assembly (wrong assembly)



CAUTION / NOTICE / HINT

NOTICE:

If the power steering ECU assembly is replaced with a new one, perform rotation angle sensor initialization and torque sensor zero point calibration (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).


PROCEDURE

1.CHECK FOR DTC (CAN COMMUNICATION SYSTEM)
a.

Using the GTS, check for DTCs and confirm that there are no problems in the CAN communication system (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM).

OK:

DTC is not output.




OK

2.CHECK ECM

NG

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

2.CHECK ECM
a.

Check if an ECM that complies with the vehicle specifications is installed.



OK

3.CHECK SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY)

NG

3.CHECK SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY)
a.

Check if a skid control ECU or a brake actuator assembly that complies with the vehicle specifications is installed.



OK

REPLACE POWER STEERING ECU ASSEMBLY

NG

REPLACE SKID CONTROL ECU OR BRAKE ACTUATOR ASSEMBLY