Home › Steering › STEERING COLUMN › STEERING WHEEL › 2012.03–2016.06
RM2090E _55 Steering _060690 STEERING COLUMN _0297647 STEERING WHEEL A

STEERING COLUMN  STEERING WHEEL  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

Do not replace the spiral cable with the battery connected and the ignition switch ON.

·

Do not rotate the spiral cable without the steering wheel with the battery connected and the ignition switch ON.

·

Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.



PROCEDURE

Hide 45116 1.INSTALL NO. 1 STEERING WHEEL ORNAMENT

a.

Engage the 2 claws and guide to install the No. 1 steering wheel ornament.


Hide 45184 2.INSTALL LOWER STEERING WHEEL BOSS COVER (w/ Cruise Control System)

Hide 45184 3.INSTALL LOWER STEERING WHEEL BOSS COVER (w/o Cruise Control System)

a.

Engage the 2 claws and install the lower steering wheel boss cover.


b.

Install the 2 screws.


Hide 45713A 4.INSTALL STEERING SHAKE DAMPER

a.

Install the steering shake damper with 2 screws to steering wheel assembly.


Hide 84610F 5.INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) (for Automatic Transmission)

Hide 6.ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

Hide 7.ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

Hide 45111 8.INSTALL STEERING WHEEL ASSEMBLY

a.
C260489E02
0.885,0.646 1.25,0.469 1.25,0.469 0.896,0.479 true 1.271,0.385 1.521,0.604 0.25,0.219 10 false *1

Install the steering wheel assembly aligning the matchmarks on the steering wheel assembly and steering main shaft.

Text in Illustration
*1 Matchmark


b.

Install the steering wheel assembly set nut.

Torque:
39 N*m (398 kgf*cm, 29 ft.*lbf)


c.

Connect the connectors to the spiral cable sub-assembly and steering wheel assembly.


Hide 9.CHECK STEERING WHEEL CENTER POINT

Hide 45130 11.INSPECT HORN BUTTON ASSEMBLY

a.

Make sure that the horn sounds.

If the horn does not sound, inspect the horn system (See page Vehicle Exterior>HORN>HORN SYSTEM>PROBLEM SYMPTOMS TABLE).