Home › Steering › STEERING GEAR / LINKAGE › STEERING GEAR
RM2090E _55 Steering _060691 STEERING GEAR / LINKAGE _0297649 STEERING GEAR A

STEERING GEAR / LINKAGE  STEERING GEAR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 44250 1.INSTALL RACK AND PINION POWER STEERING GEAR ASSEMBLY

a.

Install the rack and pinion power steering gear assembly with the 2 bolts.

Torque:
120 N*m (1220 kgf*cm, 89 ft.*lbf)

HINT:

Confirm that the rack is positioned in neutral.



Hide 45260 2.CONNECT STEERING INTERMEDIATE SHAFT ASSEMBLY

a.
C260472E01
1.511,0.7 1.964,0.524 1.964,0.524 1.488,0.623 false 1.982,0.428 2.168,0.590 0.186,0.161 10 *1

Align the matchmarks and install the steering intermediate shaft to the rack and pinion power steering gear assembly.

Text in Illustration
*1 Matchmark


b.

Install the new bolt.

Torque:
35 N*m (357 kgf*cm, 26 ft.*lbf)


Hide 45047 3.CONNECT TIE ROD END SUB-ASSEMBLY LH

a.

Connect the tie rod end sub-assembly LH to the steering knuckle with the nut.

Torque:
27 N*m (275 kgf*cm, 20 ft.*lbf)


b.

Install a new cotter pin.

NOTICE:

Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.



Hide 45046 4.CONNECT TIE ROD END SUB-ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 48811 5.INSTALL FRONT STABILIZER BAR

a.

Install the front stabilizer bar together with the rear body mounting cushion sub-assembly LH and RH to the front suspension cross member with the new 8 bolts.

Torque:
60 N*m (612 kgf*cm, 44 ft.*lbf)


Hide 48810 6.CONNECT FRONT STABILIZER LINK ASSEMBLY LH

a.
C261007

Connect the front stabilizer link assembly LH to the front stabilizer bar with the nut.

Torque:
46 N*m (469 kgf*cm, 34 ft.*lbf)

If the ball joint turns together with the nut, use a hexagon wrench to hold the stud bolt.


Hide 48820B 7.CONNECT FRONT STABILIZER LINK ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 10.INSTALL FRONT WHEELS

Torque:
120 N*m (1220 kgf*cm, 89 ft.*lbf)

Hide 11.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

Hide 12.INSPECT STEERING WHEEL CENTER POINT