Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM(w/o Entry and Start System)
RM2090E _58 Vehicle Interior _060697 THEFT DETERRENT / KEYLESS ENTRY _0297684 ENGINE IMMOBILISER SYSTEM(w/o Entry and Start System) C

THEFT DETERRENT / KEYLESS ENTRY  ENGINE IMMOBILISER SYSTEM(w/o Entry and Start System)  B1571  Immobiliser Key Check NG  


DESCRIPTION

The ECM stores this code if the main body ECU (network gateway ECU) reference code and the reference code from the ECM do not match.

DTC Code DTC Detection Condition Trouble Area
B1571 The main body ECU (network gateway ECU) reference code and reference code from the ECM do not match.
·

ECM

·

Main body ECU (network gateway ECU)



CAUTION / NOTICE / HINT

NOTICE:

If the main body ECU (network gateway ECU) or ECM is replaced, refer to Service Bulletin.


PROCEDURE

1.READ VALUE USING GTS (NUMBER OF REGISTRATION KEY)
a.

Connect GTS to DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Main Body / Data List.


e.

According to the display on the GTS, read the Data List.


Main Body
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Number of Registration Key Number of registered key/ min. 0, max. 8 Number of registered key -

Result
Result Proceed to
The registered number of the key is 0. A
The registered number of the key is 1 or more. B


A

2.REGISTER KEY

B

3.REGISTER ECU COMMUNICATION ID
2.REGISTER KEY
a.

Reregister the key (Refer to Service Bulletin).


OK:

The key ID can be registered.



OK

END

NG

4.CHECK FOR DTC
3.REGISTER ECU COMMUNICATION ID
a.

Register the ECU communication ID (Refer to Service Bulletin).


OK:

The ECU communication ID can be registered



OK

END

NG

4.CHECK FOR DTC
4.CHECK FOR DTC
a.

Check for DTCs (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM(w/o Entry and Start System)>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC B1571 is output A
Other than DTC B1571 are output B



A

5.REPLACE ECM

B

5.REPLACE ECM
a.

Temporarily replace the ECM with a new or known good one (See page Engine / Hybrid System>FA20 (ENGINE CONTROL)>ECM>REMOVAL).



NEXT

6.REGISTER ECU COMMUNICATION ID
6.REGISTER ECU COMMUNICATION ID
a.

Register the ECU communication ID (Refer to Service Bulletin).


OK:

The ECU communication ID can be registered



OK

END

NG

REPLACE MAIN BODY ECU (NETWORK GATEWAY ECU)