Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › from 2016.06
RM2090E _58 Vehicle Interior _060699 METER / GAUGE / DISPLAY _0297701 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Speedometer Malfunction  


DESCRIPTION

The combination meter assembly controls the speedometer in accordance with the vehicle speed signals from the skid control ECU (brake actuator assembly) through the CAN communication system.

WIRING DIAGRAM

E220689E12
4.688,2.125 4.896,2.281 0.208,0.156 10 false D7 4.667,2.302 5.958,2.698 1.292,0.396 10 false Combination Meter Assembly 1.115,2.125 1.552,2.281 0.438,0.156 10 false A5 1.115,2.292 3.052,2.635 1.938,0.344 10 false Skid Control ECU (Brake Actuator Assembly) 2.802,1.385 4.427,1.708 1.625,0.323 10 false CAN Communication Line

PROCEDURE

1.CHECK FOR DTC (METER / GAUGE SYSTEM)
a.

Check if meter / gauge system DTCs are output (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR).

OK:

DTCs are not output.




OK

2.CHECK FOR DTC (VEHICLE STABILITY CONTROL SYSTEM)

NG

2.CHECK FOR DTC (VEHICLE STABILITY CONTROL SYSTEM)
a.

Check if the vehicle stability control system outputs DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

OK:

DTCs are not output.




OK

3.PERFORM ACTIVE TEST USING GTS (SPEED METER OPERATION)

NG

3.PERFORM ACTIVE TEST USING GTS (SPEED METER OPERATION)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

According to the display on the tester, perform the Active Test.

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
Speed Meter Operation Speedometer 0, 40, 80, 120, 160, 200, 240 km/h -

OK:

The vehicle speed displayed on the tester is approximately the same as that of the speedometer reading.




OK

NG

REPLACE COMBINATION METER ASSEMBLY