Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CURTAIN SHIELD AIRBAG ASSEMBLY
RM2090E _58 Vehicle Interior _060701 SUPPLEMENTAL RESTRAINT SYSTEMS _0297709 CURTAIN SHIELD AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  CURTAIN SHIELD AIRBAG ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 62180A 1.INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

The power window system utilizes a mechanism that the door glass moves down slightly when the door is opened, and that the glass moves up when closing the door in order to prevent the door molding from being damaged. When the battery negative (-) terminal needs to be disconnected for servicing, fully open the driver and passenger door glasses in advance.



c.

Engage the 9 guides and install the curtain shield airbag assembly with the 9 bolts in the sequence shown in the illustration.

B311383E01
0.289,1.813 0.426,1.973 0.137,0.160 10 3 1.593,1.095 1.730,1.255 0.137,0.160 10 4 2.721,0.748 2.858,0.908 0.137,0.160 10 5 3.551,0.632 3.688,0.793 0.137,0.160 10 6 4.44,0.58 4.578,0.740 0.137,0.160 10 7 5.575,0.944 5.713,1.105 0.137,0.160 10 8 6.805,1.431 6.942,1.591 0.137,0.160 10 9 1.078,1.578 1.216,1.739 0.137,0.161 10 1 0.726,1.672 0.863,1.832 0.137,0.161 10 2

NOTICE:
·

When installing the curtain shield airbag assembly, have assistants hold it to prevent it from bending.

·

Do not twist the curtain shield airbag assembly when installing it.



HINT:

Install the bolts and guides in order, from the rear.


Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


d.
B311384E02
1.271,1.885 1.927,1.469 true 0.458,0.292 0.885,0.188 true 1.948,1.344 2.135,1.5 0.188,0.156 10 false *1 0.896,0.094 1.083,0.25 0.188,0.156 10 false *2

Connect the curtain shield airbag connector.

Text in Illustration
*1 Airbag Connector
*2 Airbag Connector Lock

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.



e.

Push in the lock to install the curtain shield airbag connector.


Hide 63310 2.INSTALL ROOF HEADLINING ASSEMBLY