Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
73220
1.INSPECT FRONT SEAT OUTER BELT ASSEMBLY
73220
2.INSTALL FRONT SEAT OUTER BELT ASSEMBLY
Engage the hook and install the front seat outer belt assembly with the 2 bolts.
Connect the pretensioner connector.
| *1 | Pretensioner Connector |
| *2 | Pretensioner Connector Lock |
When connecting any pretensioner connector, take care not to damage the pretensioner wire harness.
Push in the lock to install the pretensioner connector.
Securely lock the locking button.
Install the shoulder anchor of the front seat outer belt assembly with the bolt.
62412
3.INSTALL CENTER PILLAR GARNISH
73220
4.CONNECT FRONT SEAT OUTER BELT ASSEMBLY
Install the floor anchor of the front seat outer belt assembly with the bolt.
Check if the ELR locks.
The check should be performed with the front seat outer belt assembly installed.
With the belt assembly installed, check that the belt locks when it is pulled out quickly.
Install the floor anchor cover.
62639
5.INSTALL REAR QUARTER TRIM FRONT GARNISH
62462A
6.INSTALL REAR WINDOW SIDE GARNISH
62606A
7.INSTALL QUARTER TRIM LID SUB-ASSEMBLY
64715D
8.INSTALL LUGGAGE COMPARTMENT TRIM COVER
62312B
9.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP
67914
10.INSTALL FRONT DOOR SCUFF PLATE
11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
12.INSPECT SRS WARNING LIGHT