1. PRECAUTION
Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
The power window system utilizes a mechanism that the door glass moves down slightly when the door is opened, and that the glass moves up when closing the door in order to prevent the door molding from being damaged. When the battery negative (-) terminal needs to be disconnected for servicing, fully open the driver and passenger door glasses in advance.
87010
3.REMOVE AIR CONDITIONING UNIT ASSEMBLY (for Automatic Air Conditioning System)
87010
4.REMOVE AIR CONDITIONING UNIT ASSEMBLY (for Manual Air Conditioning System)
88897P
5.REMOVE ASPIRATOR (for Automatic Air Conditioning System)
88897A
6.REMOVE ASPIRATOR PIPE (for Automatic Air Conditioning System)
55908A
7.REMOVE AIR INLET DAMPER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System)
55906
8.REMOVE HEATER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System)
88515
9.REMOVE COOLER EXPANSION VALVE
88502A
10.REMOVE COOLING UNIT CASE SUB-ASSEMBLY (for Automatic Air Conditioning System)
88502A
11.REMOVE COOLING UNIT CASE SUB-ASSEMBLY (for Manual Air Conditioning System)
88501
12.REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
88710
13.REMOVE AIR CONDITIONER TUBE ASSEMBLY
88625
14.REMOVE NO. 1 COOLER THERMISTOR
Remove the No. 1 cooler thermistor from the No. 1 cooler evaporator sub-assembly.